Skip to main content

Getting Started

Default Network Settings​

Out of the box your device has following default network settings:

Ethernet Connection​

ParameterValue
IP2.0.0.230
Mask255.0.0.0

Wireless Connection​

ParameterValue
IPDHCP
ZeroConfighttp://pixoutserver.local

Connection Setup​

To connect to your Pixout ArtNet Recorder:

  1. Connect the Recorder to PC with Ethernet cable
  2. Power up the Recorder
  3. Setup static IP on your PC with the following values:
    • IP: 2.0.0.* (except 230)
    • Mask: 255.0.0.0
    • Gateway: 0.0.0.0
  4. Unboxed devices only - Wait for about 5 minutes until the system is initiated for the first time
  5. Type URL http://2.0.0.230/px-admin/#/network in browser address bar
  6. Specify your wireless router connection data (SSID/PSK) in Admin Panel
  7. When device is successfully connected to the wireless network, you can access it by ZeroConfig URL name http://pixoutserver.local
  8. User Panel is available at http://pixoutserver.local
  9. Admin Panel is available at http://pixoutserver.local/px-admin
tip

If you use Microsoft Windows, you need to setup Bonjour drivers first to support URLs like http://pixoutserver.local in your browser. You can download Bonjour for Windows here

Attention

Direct connection is intended for initial configuration and for sending / receiving data with ArtNet protocol. For routine work please connect by wireless and use http://pixoutserver.local